If your Washington home runs on a private well, the most useful paper you may own is the one you have never read: the well construction record. Sometimes called a driller's log or well completion report, it describes how the well was built, how deep it goes, and what kind of rock or sediment the water comes from. Pull it out before you order water tests or price any equipment, because it changes what you should check.
Where to look for the record
- Closing papers from when you bought the house, including any well disclosure or inspection report.
- Files the previous owner left behind, often in a kitchen drawer, the pump house, or with the house plans.
- The well driller's files, if the company that drilled or serviced the well is still in business.
- State well records, which may be searchable online or available by request for some wells.
- The local health or environmental office that handled permits for septic systems or wells on your property.
If you cannot find a record, that is common in older Washington neighborhoods and in rural lots along the river bottoms. Do not assume the well is shallow or deep based on the house's age. Plan to learn more from the well itself.
What to read in the record
Most records list a few key details. Focus on these first:
- Total depth. A shallow well may draw from sand, gravel, or the upper layers near the surface. A deeper well often draws from bedrock. Water chemistry can differ quite a bit between the two.
- Casing length and type. The casing is the pipe that lines the well. Its length shows how far the solid pipe extends down, and it matters for keeping surface water from entering.
- Grout or seal. The material packed around the outside of the casing near the top. A missing or short seal can let surface water travel down the outside of the pipe.
- Static water level. The depth where water stood when the well was first completed. Comparing it with later measurements can show whether the water level has changed over time.
- Yield. How much water the well produced during the original test. Older numbers may not reflect current output, but they give you a starting point.
Compare the record with the site
A record describes what was built, but the well may have changed since then. Walk the property with the paper in hand and check the following:
- Whether the well cap is intact, sealed, and free of cracks or gaps where insects or water could enter.
- Whether the vent is screened and sits above ground level, away from flood-prone low spots.
- Whether the ground around the top of the well slopes away, so rain and runoff drain off rather than pooling.
- Whether the pump house, pressure tank, or wiring shows water staining, rust, or signs of past flooding.
Write down any mismatch. For example, if the record shows a seal but you see the casing sitting at ground level with no visible grout, note that. Those notes will help a water professional decide what to test and whether the well needs inspection first.
Why this matters before testing
Depth and construction help you choose the right tests. A well drawing from deep bedrock in the Washington area may warrant a broader panel that covers naturally occurring minerals and radioactive elements found in some bedrock aquifers. A shallow well near the river may warrant closer attention to bacteria and nitrate, especially after heavy rain or flooding. Surface openings and cracked caps point toward microbial checks.
The record also keeps your lab order honest. When you send a sample, the lab usually asks for the well's depth and location. Having the real numbers on hand avoids guesses on the form, and it helps the results mean something later.
If the record cannot be found
Without a record, treat the well as unknown. Ask a qualified well professional to inspect the cap, casing top, and seal, and to tell you what can be learned from the well itself. Keep any repair invoices and inspection notes with the house papers so the next owner has a starting point. Wells are not regulated the way a public system is, so the homeowner is usually the only one checking. A written record of the well's construction is one of the few things that makes that job easier.
Next steps
- Gather whatever paperwork exists and search state records for your address.
- Note depth, casing, seal, and static level in one place.
- Inspect the cap, vent, and grade around the well, and write down what you see.
- Use those details to choose your test panel before you collect a sample or buy equipment.