Many Washington homeowners notice a rumbling, popping, or sizzling sound when the burner or element turns on to heat the water. In a town where local public water reports describe very hard water, that noise is often mineral sediment settling at the bottom of the tank. The sediment builds up slowly, and a tank with a layer of it on the floor can take longer to heat water and may run less efficiently than it did when it was new.

Homes on private wells in the Franklin County area along the Missouri River bottoms can have hard water and iron at the same time. Iron can add a rust-colored or dark layer to the sediment, so the flushing steps below apply to both public and private supplies. Check your water report or well records first so you know what you are dealing with.

What to Check Before You Drain Anything

Start with observation. Most of these checks take only a few minutes and do not require tools.

  • Listen while the heater is heating. Rumbling or popping that gets louder over time often points to sediment.
  • Notice whether hot water takes longer to arrive or whether the tank seems to run out sooner than it used to.
  • Look at the age of the tank and any labels on the unit. The manufacturer's manual, if you still have it, usually lists a recommended flushing interval.
  • Find out whether your home has a water softener upstream of the heater. A softener changes what reaches the tank, and its settings matter for how fast sediment forms.
  • Check nearby fixtures for staining. Orange or brown marks on sinks and tubs are a hint that iron may be part of the picture on a well system.
  • Confirm the heater's power source and shutoff points before you start, including the breaker for an electric unit or the gas control for a gas unit.

Flushing the Tank Safely

Flushing is a simple job for many homeowners, but the water inside the tank can be hot enough to cause a burn, so let the tank cool first and wear gloves. Follow these steps in order.

  1. Turn off power to an electric heater at the breaker, or set a gas heater's control to the off position.
  2. Shut off the cold water supply valve that feeds the heater.
  3. Attach a garden hose to the drain valve near the bottom of the tank. Run the other end to a floor drain or outside, away from walkways and landscaping you care about.
  4. Open a hot tap somewhere else in the house. This lets air into the system so the water drains more freely.
  5. Open the drain valve and let water run until it comes out clear. Sediment may come out in small amounts over a few minutes, so be patient.
  6. Close the drain valve, disconnect the hose, open the cold supply valve, and let the tank refill. Close the hot tap once you see a steady stream without air bursts.
  7. Restore power or gas only after the tank is full. Running an electric element or gas burner on an empty tank can damage it.

When to Call a Licensed Plumber

If the valve will not open, if the drain water stays cloudy or gritty after several flushes, or if you find water leaking around the tank, stop and have a licensed plumber in Washington look at it. Older tanks sometimes have a sacrificial anode rod inside, and a plumber can check its condition as part of the same visit. Very hard water and sediment can make the anode rod harder to remove, so do not force it yourself.

Keep a Simple Record

Write down the date of each flush, what the drained water looked like, and any changes you noticed in noise or hot water timing. A short log helps you decide how often to flush and gives a plumber useful information during a repair. Keep the log with your water report and any well records you have.