Shock chlorination means adding chlorine to a private well and its plumbing to disinfect them. Homeowners in Washington usually reach this step after a flood, after a repair that opened the well, after a lab result that flagged bacteria, or after a long stretch without use. Private wells in the Franklin County river-bottom area can be affected by surface water after heavy rain, so many owners end up here after a storm. Good preparation decides whether the job is thorough and whether the retest tells you anything useful.

Shock chlorination is a disinfection step, not a fix for every water problem. It does not remove iron, hardness, or radium, and a treated well still needs testing afterward. Treat this guide as a homeowner checklist, and bring a qualified well contractor or your local health office into the plan whenever you are unsure of a step.

Checks Before You Start

  • Find your well construction record and note the well depth, casing type, and where the pump and pressure tank sit. The record helps you trace the water path through the system.
  • Confirm the well cap and vent are intact. A cracked cap or open vent can let surface water back in and undo the treatment.
  • Identify any filter, softener, or UV unit on the line. Chlorine can harm some resin and media, so plan to bypass or remove those parts as the equipment maker or your installer directs.
  • Look for iron staining, slime, or a strong odor in the house and at outdoor hose bibs. Heavy iron and slime can use up chlorine and make the job less effective, so write down what you see.
  • Pick a day when no one needs water for several hours, and tell everyone in the house what is happening.

Gather Supplies and Plan the Flow

Have a disinfectant labeled for potable water use, a clean hose, and a safe way to handle the chlorinated water. Do not let it run into a ditch, a pond, or onto a lawn close to the well. Check local rules on disposal before you start. Plan the flow path so the solution reaches the pump system first, then each tap in turn, until a chlorine odor shows at the farthest fixture. Then let the system sit for the contact time your well professional or reference guide specifies.

Work from the well outward. Start at the wellhead, move through the house, and finish at outdoor spigots and any ice maker or water heater line. Open each fixture until the chlorine smell appears, then close it and move on. Keep notes as you go so you can see later which lines were reached.

Mistakes That Make the Retest Misleading

  • Testing too soon after the job. Leftover chlorine or an incomplete rinse can make early results unreliable.
  • Skipping outdoor spigots, the water heater, or the ice maker line. These can hold water that the solution never reached.
  • Running the system with the filter still in place. Media may stay contaminated, or chlorine may damage it.
  • Ignoring the cause. If the cap, casing, or a nearby drainage problem let water in, the same issue can return after the job is done.

Flushing and Rinsing Afterward

Once the contact time is over, flush the system until the chlorine odor and taste are gone from every tap you tested. Replace any filter cartridges you removed, and reconnect bypassed equipment only after the rinse is complete. Watch the pressure tank and pump during the rinse so the system cycles normally.

After the Job

When the system is flushed and chlorine is gone from the taps, schedule a lab test. Use a certified lab, follow its sample instructions closely, and keep the results with your well records. Keep a simple log with the dates, what you did, and each test, so the next owner of the house can see the history. If the result is still positive, or if a chlorine taste keeps returning, call the health office or a well professional rather than repeating the job alone.