If your cold tap runs clear with no odor but the hot tap smells like rotten eggs, the problem is probably inside your home, not in the water supply itself. Homes in Washington see this on both private wells and public water, and the fix is often simpler than people expect. The first job is to figure out where the smell is coming from.

What the smell usually is

The rotten egg odor is most often caused by hydrogen sulfide gas. Sulfur-reducing bacteria can produce it in water heaters, and certain chemical reactions inside a tank can release it too. Private wells in the Franklin County area sometimes carry sulfide in the groundwater, especially deeper bedrock wells, so a well owner should not assume the water heater is the only possible source. A smell by itself does not tell you the cause, so the checks below are meant to narrow things down.

Check whether only the hot side smells

Run the cold and hot taps separately at the kitchen sink and a bathroom. Use a clean glass and let each tap run for a short while before you smell it.

  • If both hot and cold smell, the issue is likely in the source or the main supply line, so move on to the testing section below.
  • If only the hot side smells, the water heater is the most likely place to look first.
  • If the smell appears only on one fixture, check that fixture's own supply line and any filter or aerator attached to it.

Water heater checks to make first

Start with the tank itself, since most cases of this odor begin there. Before doing any work on the heater, turn off the power or gas supply and let the water cool.

  1. Find out what type of anode rod is installed. Magnesium rods are more often linked to this odor in water with higher sulfate, while aluminum or zinc-aluminum rods are used in other situations. Reading the label on the top of the tank or the rod head can help.
  2. Look at the thermostat setting. A very high setting can speed up the chemical reactions that produce odor, so a modest reduction is a reasonable thing to try and watch for a change.
  3. Drain some water from the bottom of the tank to clear out sediment, then run the hot tap again. Sediment buildup can hold bacteria and odor-producing material.
  4. If the rod is accessible, have it pulled and inspected. A heavy coating or a rod that is badly worn suggests the tank has been reacting with the water for a long time.

If the smell returns quickly after these steps, or if you are not comfortable working on the tank, a licensed plumber can inspect the rod and tank without much fuss.

Test before you treat

Treating the water without knowing what is in it can waste money and may not solve the problem. A simple test gives you something concrete to act on.

  • Use a home test kit for hydrogen sulfide if you want a quick yes or no on the smell source.
  • Order a certified lab test for sulfide, bacteria, and other common constituents if you are on a private well. Ask the lab which tests fit your situation.
  • Collect the sample from the hot tap and the cold tap separately so you can compare them. Keep the sample cold and deliver it to the lab promptly.

Well owners need to think about the source

If your home is on a private well, the smell may come from the aquifer, the well construction, or the surface around the well. Deeper bedrock wells can carry sulfide along with other constituents, so a smell that shows up at both taps deserves a full look at the well, not just the water heater. Well construction records and past test results can help you decide what to check first. Nobody tests a private well for you, so the responsibility to sample and track results rests with the owner.

When to stop and get help

  • The smell is strong enough that you do not want to use the water for drinking or cooking until you know the cause.
  • The smell appeared suddenly after flooding, heavy rain, or well work.
  • The hot tap smell continues after you have drained the tank and adjusted the heater.
  • Lab results show constituents you do not understand and you need help reading them.

Washington homes have a range of water sources, so the right next step depends on whether the smell is limited to the hot side or shows up everywhere. Start with the checks above, keep notes on what you tried and what changed, and bring those notes with you if you need to call a professional.