Washington sits in Franklin County, where river-bottom ground can stay saturated for days or weeks after heavy rain or a river rise. If your home runs on a private well, nobody else tests that water for you. The public utility report does not describe your well, and no agency checks it on a schedule. After a flood, the work is to look at the well, check the equipment, collect the right samples, and keep your own record until results come back.
Start with the outside of the well
Walk the property before you touch the pump. Look at the well cap, the vent, and the casing at ground level. Note whether the ground around the well is soft, sunken, or still holding standing water. Check for silt or mud on the cap, a cracked or missing seal, or debris that washed against the casing. Take dated photos of each item. These notes matter later if you need to explain what the well looked like after the flood.
Check the pump and electrical equipment
Floodwater can reach the pump house, the pressure tank, the control box, and the wiring. Before you switch the pump back on, have a qualified well professional inspect the electrical connections and controls. Do not restart a pump that was under water until the wiring has been checked. Look inside the pressure tank access points and the pump house for mud or standing water, and note what you find.
Choose the tests that matter first
For a flooded well, bacteria testing is usually the first step. A bacteria test looks for coliform bacteria and E. coli, which show whether surface water may have reached the well. Ask the lab which method it uses and how quickly it reports results. Add nitrate if the flood may have reached a septic field or nearby farm ground, since nitrate can come from both sources. Iron and hardness are usually obvious to a homeowner before a flood, so they rarely drive the first decision.
If your well has a history of naturally occurring minerals in deeper groundwater, pull out your older well report. Compare it with the new results so you can see what changed. The Cambrian-Ordovician aquifer can carry naturally elevated radium in parts of the region, so a prior report that already tested for radium is worth finding before you decide what else to add.
Collect samples the right way
- Use the bottle and instructions the lab provides, and do not rinse the bottle.
- Follow the lab's directions for running the tap before collecting.
- Keep the sample cool and deliver it promptly.
- Write down the date, the time, the tap used, and any recent work on the well.
Plan water use while you wait
Until results come back, ask the lab and your county health office what they recommend for drinking, cooking, brushing teeth, and bathing. Follow that advice rather than guessing. Keep a written log of the flood timeline, inspections, repairs, and sample dates, and keep the lab reports with it.
If results show a problem
A positive bacteria result or an elevated chemical result means you should act before relying on the water for drinking. A licensed well contractor can advise on disinfecting the well and on finding the source of the problem, such as a damaged cap or a nearby contamination path. After any repair or disinfection, retest. One result does not close the question, and a follow-up sample confirms whether the fix worked.
Keep the records
Store the lab reports, photos, inspection notes, and repair invoices in one folder. Results from before and after a flood, compared side by side, show whether the well is changing over time. Retest after heavy rain, after any repair, and on a regular schedule you set for your household.